E-mail :: 
Print
You may select a topic from the left column to view a specific section in the page
Technical Light Pattern
|
Technical Light Pattern
- Make sure power light is solid
- Make sure Cable light is solid indicating registration is complete
- Make sure Link/Act light is solid (1 to 4) for eachwired connection
- Make sure WLAN light is lit indicating a wireless connection
- Make sure USB light is solid if using the device's USB port
|
back to top »
Good Light Pattern
|
Good Light Pattern
- Make sure power light is solid
- Make sure Cable light is solid indicating registration is complete
- Make sure Link/Act light is solid (1 to 4) for eachwired connection
- Make sure WLAN light is lit indicating a wireless connection
- Make sure USB light is solid if using the device's USB port
|
back to top »
RF or Bad Light Patterns
|
RF or Bad Light Patterns
If the cable link light is flashing and won't go solid then this usual means that there is an RF issue present or that the modem is suspended
|
back to top »
Modem Internals
|
Modem Internals
|
1.Start Internet Explorer
2.Type http://192.168.0.1 in the adress bar and press Enter
3.Enter "admin" for the username and either "1234" or "password" for the password. (Depends on Software version)
|
back to top »
Modem Internals Basic Settings
|
Modem Internals Basic Settings
|
back to top »
Modem Internals Gateway Status
|
Modem Internals Gateway Status
|
back to top »
Modem Internals Signal Information
|
Modem Internals Signal Information
|
back to top »